On my Regina the Bowden cables were in a bad condition or missing.
Until now i never soldered my cables by myself. So i decided to buy a set of new cables from a known HOREX parts dealer.
The next ones i will try to make by myself if necessary. For this i took the dimensions from the new ones:
Dimensions:
Diameter inner cable: 2mm
Inner cable lenght: 990mm
Outer cable lenght: 820mm
Actuation side:
Barrel: 8x4x9mm
Cable End: 6x3,5x13mm soldered
Regulating side:
Adjustable screw: M7, total lenght: 45mm, thread lenght: 35mm
Cable End: 6x3,5x13mm soldered
The cables are not mounted at the moment, so i canīt test them.
Here a advice form Max and Dietmar from the HOREX Forum: Before discard the old cables, test the new ones.
Also to have a set of inner cables and screw-nipples in the baggage, is a good idea.
Dimensions:
Diameter inner cable: 1,5mm
Inner cable lenght: 865mm
Outer cable lenght: 755mm
Actuation side:
Cable End: 6,5x4mm (diameter/width) soldered
Regulating side:
Cable End: 3,2x5mm soldered
Dimensions:
Diameter inner cable: 1,5mm
Inner cable lenght: 980mm
Outer cable lenght: 870mm
Actuation side:
Cable End: 6x5,5mm (diameter/width) soldered
Regulating side:
Cable End: 3,2x5mm soldered
Dimensions:
Diameter inner cable: 1,5mm
Inner cable lenght: 730mm
Outer cable lenght: 620mm
Actuation side:
Cable End: 6,5x4mm (diameter/width) soldered
Regulating side:
Adjustable screw: M6, total lenght: 32mm, thread lenght: 20mm
Cable End: 5x5mm soldered
Dimensions:
Diameter inner cable: 2mm
Inner cable lenght: 1310mm
Outer cable lenght: 1225mm
Actuation side:
Barrel: 8x4x9mm
Cable End: 6x3,5x13mm soldered
Regulating side:
Cable End: 5x5mm soldered
